set of two licensed Die Cut decals are made of outdoor vinyl, permanent
adhesive, image cut to the outside dimension of logo, full color detail
is printed with a 3 year outdoor rating. Supplied with a clear liner,
clear transfer tape, and application instructions are on the back of the
card and on line. Made in the USA.
Directions for application:
1. Clean surface thoroughly (temperature should be above 50° f)
2. Turn decal upside-down (imprint side down) and place on a flat surface.
Separate the clear liner from the foggy “pre-mask” material making
sure the decal stays attached to the “pre-mask”. If needed, use your
fingernail to hold the edge of the decal to the “pre-mask” when removing
Carefully place decal in desired position. With fingers (or a credit
card) firmly rub decal from the center out in all directions.
5. Remove “pre-mask” at a 180 degree angle (rub down decal as necessary).
6. Puncture bubbles with sharp needle; then lightly press area to remove trapped air.